Tucker The Golden Retriever
Tucker the Golden Retriever is here, he is happy about it, and he would very much like you to know both of those things. This hand-finished 3D printed sculpture is printed and finished right here at my workshop in the Netherlands, and he arrives ready to be the best thing on your shelf.
✦ About Tucker
Tucker loves everyone, unconditionally, immediately, and with his whole chest. His detailed design gives him a friendly yet majestic look, and though he may seem small, his heart is as boundless as his playful spirit. He's the kind of companion who makes wherever he's placed feel a little warmer. Give him a cosy spot, keep him dust-free with the occasional soft cloth wipe, and he'll reward you with a permanently cheerful expression.
✦ Fun Fact
Golden Retrievers were originally bred in Scotland in the mid-1800s as gun dogs, trained to retrieve waterfowl during hunts. Their famously soft mouths, gentle enough to carry an egg without breaking it, were a key part of the job. Tucker has retained this gentleness entirely, though his retrieving these days is limited to your attention and goodwill.
Tucker's measurements are approximately 12 × 6.5 × 14 cm (L × W × H). Because Tucker was designed as a figurine and not as a toy, please be careful with him when children are around, everything has been sanded down where needed for safety, but some sharp parts could still be present.
Designed by DeltaPrints. Printed, finished and shipped by Hand of Stardust.
- Lead time
- Printed after you order: usually leaves the workshop in 2 to 4 days.
- Size
- 6,5 × 14 × 12 cm
- Shipping
- Tracked from the Netherlands. Free over €50.
Living with a print
It's a print, so it reads like one up close. Seams get sanded, supports get cleaned off, nothing gets filled in to fake a moulded look.
PLA starts to soften around 50 °C. A sunny windowsill is fine: a parked car in August is not.
Dry brush or a soft cloth. If it needs more than that, lukewarm water and patience: no solvents.
