The Midnight Fae - Bookshelf Decoration - 3D Printed - Hand of Stardust
Book & Bookshelf Accessories · 3D Printed

The Midnight Fae - Bookshelf Decoration

€14,99 Taxes included · shipping at checkout

She doesn't need a name, the books she devours speak for her. The Midnight Fae is a bookshelf decoration for readers who live in the pages long after the lights go out, printed and finished by hand right here at my workshop in the Netherlands.

Designed by TheForbiddenNerd. Printed, finished and shipped by Hand of Stardust.

✦ About This Piece

A mysterious cloaked woman, curling hair falling across her face, deep in a book that clearly has her entire soul. The wrinkling of her cloak, the gentle folds of the pages, the quiet intensity of her posture, every detail rewards a closer look. Fully finished and ready to sit on your shelf the moment she arrives.

Here's what her designer had to say about her:
"She has hidden desires, devours her stories to reach the eternal portal of alternate realms, and craves the intoxicating pull of danger she so desperately clings to."

✦ Who Is She For?

The Midnight Fae doesn't belong to a specific book or series: she belongs to a feeling. If you're a dark fantasy or romantasy reader who sees yourself in every morally grey heroine, every atmospheric midnight chapter, every story that pulls you somewhere you can't quite come back from, she was made for your shelf. A perfect gift for any reader who takes their bookshelf as seriously as their TBR.

Lead time
Printed after you order: usually leaves the workshop in 2 to 4 days.
Size
5,5 × 18 cm
Shipping
Tracked from the Netherlands. Free over €50.
✦ Dimensions

Measured at its widest points

The filled box is this piece's footprint on a shelf, measured across its widest points. The dashed boxes beside it are everyday objects drawn to the same scale, so you can judge the size against something you already own.

Width5,5cm
Height18cm
1020300 cm
18
5,5cm This piece
Bank card8,6 cm
Drinks can11,5 cm
Phone14,7 cm
Paperback20 cm
A4 sheet29,7 cm
✦ Finish and care

Living with a print

Layer lines, honestly

It's a print, so it reads like one up close. Seams get sanded, supports get cleaned off, nothing gets filled in to fake a moulded look.

Keep it out of hot cars

PLA starts to soften around 50 °C. A sunny windowsill is fine: a parked car in August is not.

Dusting

Dry brush or a soft cloth. If it needs more than that, lukewarm water and patience: no solvents.