Fourth Wing Bookmark Collection – Complete Set of 5 - 3D Printed - Hand of Stardust
Book & Bookshelf Accessories · 3D Printed Bookmark

Fourth Wing Bookmark Collection – Everything from Set 2

€22,99 Taxes included · shipping at checkout

This is the second complete set, five new bookmarks from the Fourth Wing-inspired collection, ready to mark every chapter of the Empyrean series in style. Whether you're keeping them all for yourself (valid) or gifting them to a fellow reader (extremely valid), this is the set that belongs together.

  • Quest Squad, crescent moon, mountain peaks, and found-family energy
  • Shadow Xaddy, twin dragon wings in silk gold on black, for the Xaden fans
  • Among Dragons, three dragons in flight, white and gold colourway
  • In My Fantasy Era, because it's not a phase, it's a lifestyle
  • Save a Dragon, Ride a Wing Leader, for the readers with absolutely no shame about it

This is the second full set of the Fourth Wing inspired bookmarks.

Designed by C3D. Printed, finished and shipped by Hand of Stardust.
Inspired by the Fourth Wing / Empyrean series by Rebecca Yarros.
Multi-colour 3D printed in silk gold, black & white PLA.
Approximately 8.5 × 3 cm each.

Perfect as a gift for romantasy readers, BookTok fans & collectors.

Prefer where it began? The original Set 1 bundle is here.

Lead time
Printed after you order: usually leaves the workshop in 2 to 4 days.
Size
5,5 × 18 cm
Shipping
Tracked from the Netherlands. Free over €50.
✦ Dimensions

Measured at its widest points

The filled box is this piece's footprint on a shelf, measured across its widest points. The dashed boxes beside it are everyday objects drawn to the same scale, so you can judge the size against something you already own.

Width5,5cm
Height18cm
1020300 cm
18
5,5cm This piece
Bank card8,6 cm
Drinks can11,5 cm
Phone14,7 cm
Paperback20 cm
A4 sheet29,7 cm
✦ Finish and care

Living with a print

Layer lines, honestly

It's a print, so it reads like one up close. Seams get sanded, supports get cleaned off, nothing gets filled in to fake a moulded look.

Keep it out of hot cars

PLA starts to soften around 50 °C. A sunny windowsill is fine: a parked car in August is not.

Dusting

Dry brush or a soft cloth. If it needs more than that, lukewarm water and patience: no solvents.