Card Display Riser - Honeycomb Pattern

For card vendors, having display risers like this this in your display case allows you to easily show your cards at a convenient angle for potential buyers.

The raised edge at the front of the riser keeps each card standing at a slight backward lean: steady enough for cards, toploaders and slabs but still easy to swap when you want to switch out items.

I offer them in three sizes, allowing you to easily mix and match them into whichever configuration you want to set up.  

Printed, finished and shipped by Hand of Stardust. 
Toploaders seen in photo are an example layout and are not included.
Designed with raw cards, sleeved cards, toploaders and graded slabs in mind.
But also works with other flat items that are of similar weight!
 
If you want to mount a single slab on its own, my decorative graded card frames are built for that.

✦ Display case compatibility

For use inside a display case: make sure to have at least the listed depth below to ensure your items will have enough clearance between the top of the product and the lid of your case.

Anything less than the mentioned clearance, and you will risk pushing against the products on the riser. Which can potentially damage them, and I would hate that to happen.

So, after extensive testing, these are the minimum case depths I found work best:

• Top loaders / semi-rigid sleeves: 2.25cm minimum case depth
• Graded slabs (PSA, CGC, Beckett): 3.5cm minimum case depth

✦ The Three Sizes I Mentioned

• Narrow (90 × 90mm)
  • Great for a single standout card, one you want to highlight.
• Regular (180 × 90mm)
  • Gives you room for a small row. 
• Wide (250 × 90mm)
  • Great for displaying a set, a favourite run, or your hero lineup!

✦ Different Delivery Time Note

This product has become a big unexpected success, so thank you very much for that! However, since this is a made-to-order product like everything I offer, it could be that I have to make a lot in a week and cannot guarantee my regular delivery times with my current printing capacity.

If you are ordering against a deadline, send me a message on Instagram at @handofstardust before you order. That way I can tell you honestly whether I can make it in time. I would rather be upfront than leave you waiting.