Flatpack Mini Display Stand

€1,99 Taxes included · shipping at checkout

Een handige manier om kleine voorwerpen zoals foto's of een van de onderzetters die ik in de winkel aanbied, tentoon te stellen! Ze zijn ook een geweldige manier om de gepersonaliseerde 3D-prints te presenteren. Elk van de beschikbare kleuren past bij de Eeveelution onderzetters. Het opzetten van de standaard vereist slechts één stap: schuif de twee delen gewoon in elkaar.

Alle onderdelen zijn uitwisselbaar, dus voel je vrij om je favorieten te combineren!

Lead time: Printed after you order: usually leaves the bench in 2 to 4 days.
Shipping: Tracked from the Netherlands. Free over €50.

✦ Stardust Finish

Assembled and ready to display

Every piece arrives as a Stardust Finish: printed in its own colours and put together by hand, ready to go straight on the shelf.

Prefer the hands-on version? There's a Builder's Kit too: every part printed in the right colour, unassembled, yours to put together. Message me and I'll sort it.

✦ Finish and care

Layer lines, honestly

It's a print, so it reads like one up close. Seams get sanded, supports get cleaned off, nothing gets filled in to fake a moulded look.

Keep it out of hot cars

PLA starts to soften around 50 °C. A sunny windowsill is fine: a parked car in August is not.

Dusting

Dry brush or a soft cloth. If it needs more than that, lukewarm water and patience: no solvents.

✦ Scale, honestly